Introduction; Tape Drive Numbering - Quantum Tape Drive Scalar 50 Installation Instructions Manual

Introduction

Tape Drive Numbering

Figure 1 Scalar 50 Cable
Configuration (Full Height
Drives)
This document provides instructions for adding a tape drive to an Scalar 50
tape library. The tape drive upgrade procedure consists of the following
steps:
Note: Half-height tape drive canisters are ONLY available in Scalar 50
tape libraries.
• Unpacking the Tape Drive
• Installing the Tape Drives
• Cabling the Tape Drives
• Setting the Tape Drive SCSI ID
• Completing the Native Fibre Channel Installation
• Fibre Channel Connectivity Troubleshooting
0
The Scalar 50 tape library may contain up to 4 tape drives depending on the
tape drive type. Refer to the following figures:
• Figure 1 Full height drives (up to two per library)
• Figure 2 Half-height drives (up to four per library)
Quantum Scalar 50 Tape Drive Installation Instructions
Tape drive 2
Introduction
Document 81-81769-01 B01
September 2007
Tape drive 1
Back of Library
0
3