Figure 110 Scalar 50 Tape Drive Numbering - Quantum Scalar 50 User Manual

Figure 110 Scalar 50 Tape
Drive Numbering
Quantum Scalar 50 User's Guide
a Insert the tape drive into the drive bay slowly until the
connectors are seated (see
Tape
drive 2
Tighten the tape drive captive screws using a flat blade
b
screwdriver.
c Repeat these steps to install another tape drive in a different
location, if desired.
The library chassis is installed in the rack.
Cabling the Library
Connect the SCSI cables and jumpers as shown in the following figure:
• Scalar 50 Cable Configuration (SCSI Full Height Drives)
• Scalar 50 Cable Configuration (Native Fibre Channel Full Height
Drives)
• Scalar 50 Cable Configuration (SCSI Half-Height Drives)
• Scalar 50 Cable Configuration (SAS Half-Height Drives)
Appendix C Installing the Scalar 50 Library
figure 110).
Tape
drive 1
Installing the Library
3
202