Dhcp Setting - Muratec MFX-1450 Software Manual

DHCP setting

If a DHCP (Dynamic Host Configuration Protocol) server is installed on your net-
work, the machine will automatically be assigned an IP address and Subnet Mask
the first time the machine is turned on. According to the DHCP server setting, a
Gateway address and DNS server address may be assigned as well.
IMPORTANT
• Once the DHCP server has assigned the IP address to your machine, that IP
address MUST be reserved within the specific DHCP scope. Failure to do so could
result in failed operation when the IP address lease expires.
• After an IP address is assigned to your machine, please turn the DHCP server
setting to "OFF". (Press <Setting>, [Management], [Network Settings], [TCP/IP
Settings], [DHCP Setting], and then [OFF] and [Enter].)
NOTE
• You can view the assigned addresses on the TCP/IP setting menu display.
• The IP address and Subnet Mask assigned from the DHCP server cannot be
modified.
• A "Gateway Address" and "DNS server address" will not be assigned, if the pri-
mary and secondary address have already been registered.
• If you are not utilizing a DHCP server, please turn DHCP to "OFF" and manually
assign the IP address and Subnet Mask. See pages 1-8 and 1-9 for operational
instructions.
PC_Users_Guide.indb 7
tcP/iP 1-7
SettinGS
2007/04/27
1
2
3
4
5
6
7
8
9
10
11
12
13
AI
10:17:40