Tickets With Black Mark - Intermec EasyCoder PD41 User Manual

Appendix B — Media Specifications

Tickets with Black Mark

a: Media Width
Maximum:
Minimum:
b: Copy Length
8 dots/mm (203 dpi)
Maximum:
Minimum:
11.81 dots/mm (300 dpi)
Maximum:
Minimum:
* This is the print length limit set by memory constraints.
c: Detection Position
Variable:
d: Black Mark Width
The detectable width of the black mark should be at least 5.0 mm (0.2
inches) on either side of the Label Gap Sensor detection point.
e: Black Mark Length
Maximum:
Minimum:
Common:
f: Black Mark Y-Position
It is recommended that you place the black mark as close to the front
edge of ticket as possible and use a negative Stop Adjust value to
control the media feed, so the tickets can be properly torn off.
Paper Type Setup
• Tickets with Mark
66
118.0 mm
25.0 mm
Fingerprint
1270 mm (50 in.)*
6 mm (0.2 in.)
558.8 mm (22 in.)* 406.4 mm (16 in.)
6 mm (0.2 in.)
0 to 57 mm 0 to 2.24 inches
25.0 mm
3 mm
5 mm
EasyCoder PD41 Printer User's Guide
4.65 inches
1.00 inches
IPL
600 mm (23 in.)
6 mm (0.2 in.)
6 mm (0.2 in.)
0.98 inches
0.12 inches
0.2 inches