Installing The Print Catcher - Kodak 8800 User Manual

Label/wrapper
Take-up spool

Installing the Print Catcher

Print catcher
July 2006
Remove the label/wrapper from the ribbon.
5.
Push the right side of the take-up spool into the rear spool holder on the
6.
right.
Place the left side of the take-up spool into the rear spool holder on the
7.
left.
Rotate the take-up spool until it locks into place.
8.
If there is any slack in the ribbon, remove it by turning the take-up spool.
9.
Slack in the ribbon can cause a paper jam when making
IMPORTANT:
prints.
The print catcher collects finished prints as they exit the printer.
• Set the print catcher into the printer as shown.
4J2007
Setting Up the Printer
1-7