Omron SYSMAC CJ - REFERENCE MANUAL 08-2008 Reference Manual page 882

Interrupt Control Instructions
Operand Specifications
842
■
Resetting and Starting Scheduled Interrupts (CJ1M CPU Units Only)
Operand
N Specify the scheduled interrupt number.
14: Scheduled interrupt 0 (interrupt task 2)
15: Scheduled interrupt 1 (interrupt task 3)
Note Only scheduled interrupt 0 can be used with the CJ1M-CPU11/21.
C Scheduled interrupt
time units (Set in the
PLC Setup.)
Any time unit setting
10 ms
1 ms
0.1 ms
Area
CIO Area
Work Area
Holding Bit Area
Auxiliary Bit Area
Timer Area
Counter Area
DM Area
EM Area without bank
EM Area with bank
Indirect DM/EM
addresses in binary
Indirect DM/EM
addresses in BCD
Constants
Data Registers
Contents
Scheduled interrupt set time
0 decimal (0000 hex):
Disable interrupt. (Stop internal timer.)
1 to 9,999 decimal (0001 to 270F hex):
Enable interrupt. (Reset internal timer value, and
then start the timer with an interrupt interval
between 10 and 99,990 ms.)
1 to 9,999 decimal (0001 to 270F hex):
Enable interrupt. (Reset internal timer value, and
then start timer with an interrupt interval
between 1 and 9,999 ms.)
5 to 9,999 decimal (0005 to 270F hex):
Enable interrupt. (Reset internal timer value, and
then start timer with interrupt interval between
0.5 and 999.9 ms.)
Note Settings 0001 to 0004 cannot be used. An error
will occur if one of these settings is used.
N
---
---
---
---
---
---
---
---
---
---
---
Specified values only
---
Section 3-20
S
CIO 0000 to CIO 6143
W000 to W511
H000 to H511
A000 to A959
T0000 to T4095
C0000 to C4095
D00000 to D32767
E00000 to E32767
En_00000 to En_32767
(n = 0 to C)
@ D00000 to @ 32767
@ E00000 to @ 32767
@ En_00000 to
@ En_32767
(n = 0 to C)
*D00000 to *D32767
*E00000 to *E32767
*En_00000 to *En_32767
(n = 0 to C)
DR0 to DR15