Block Program Pause/Restart: Bpps(811)/Bprs(812) - Omron SYSMAC CJ - REFERENCE MANUAL 08-2008 Reference Manual

Block Programming Instructions
Examples

3-32-3 BLOCK PROGRAM PAUSE/RESTART: BPPS(811)/BPRS(812)

Purpose
Ladder Symbol
Variations
BPRG(096) and the corresponding BEND(801) must be in the same task.
An error will occur and the Error Flag will turn ON if BPRG(096) is in the mid-
dle of a block program, BEND(801) is not in a block program, N is not between
#0000 and #007F (binary), there is no block program, or if the same block pro-
gram number is used more than once.
When CIO 000000 turns ON in the following example, block program 0 will be
executed. When CIO 000000 is OFF, the block program will not be executed.
0
The two program sections shown below both execute MOV(021), ++B(594),
and SET for the same execution condition (i.e., when CIO 000000 turns ON).
Pause and restart the specified block program from another block program.
BPPS(811)
BPRS(812)
Variations Always Executed in Block Program
Block program 0
0
N
N: Block program number
N
Section 3-32
1193