System Configuration; Cj1W-Nc413 System Configuration Example - Omron CJ1W-C113 - REV 02-2008 Operation Manual

System Configuration

1-2

System Configuration

1-2-1

CJ1W-NC413 System Configuration Example

Use for setting
data and
monitoring.
Computer:
CX-Position
CX-Programmer
Dedicated terminal block
(See note.)
Pulse output
Stepping
motor
drivers
Stepping motors
4
The PCU receives control signals (CW limit, CCW limit, origin, origin proxim-
ity, emergency stop, and external interrupt input signals) from devices and a
control panel, and outputs pulse trains to stepping motor drivers and Servo
Drives.
Editing parameters and data.
Monitoring status.
File management.
Power
CJ-series
Supply
CPU Unit
Unit
Connection to
RS-232C port
Connection to peripheral port
Dedicated terminal
block
External input signals
CCW limit
CW limit
Origin (See note 2.)
Origin proximity
Emergency stop
External interrupt
24-V DC power
supply for I/F
Servo Drives
(See
note
2.)
or
Servomotors
Note (1) A dedicated cable is available for connecting the PCU to the dedicated
terminal block.
(2) Origin input signals cannot be used as external connection terminals with
dedicated terminal blocks. Connect the Z-phase signal to the Servo Drive
using the dedicated cable. The connecting cable required between the
PCU or dedicated terminal block and stepping motor driver is not provid-
ed.
CJ1W-NC413
Position Control Unit
External input signals
CCW limit
CW limit
Origin (See note 2.)
Origin proximity
Emergency stop
External interrupt
24-V DC power
supply for I/F
Pulse output
Stepping
motor
drivers
(See
note
2.)
or
Stepping motors
Section 1-2
Servo Drives
Servomotors