Network Settings Panel - Extron electronics SW USB Pro Series User Manual

Network Settings Panel

In the
Network Settings
subnet mask, and gateway address for the SW USB Pro, and turn DHCP on and off. You can also view the unit
MAC address. To enter network settings:
1. Click Edit in the lower-left corner of the
Figure 24. Network Settings Edit Screen
2. Edit the network settings as desired:
•
Hostname — To change the unit name, click in this field and enter the desired name (see figure 24,
• DHCP — Click the DHCP button (
configures its IP address and other network settings from the DHCP server. The default is Off.
• IP Address, (
in the desired field and enter the address.
3. When finished editing, click Save (see figure 24,
without making changes. You can also close the window by clicking the X in the upper-right corner of the
screen.
NOTE: If DHCP is being enabled, the web page attempts to redirect and connect to the unit via the unit name
(TCP/IP hostname). If a static IP address is being set, the web page attempts to connect to the new IP
address.
panel (see figure 17,
Network Settings
) to toggle DHCP on and off. When DHCP is enabled (On), the unit
2
), Subnet mask ( ), and Gateway address (
3 4
, on page 32), you can set the unit name (hostname), IP address,
5
panel. The
) to confirm your changes or Cancel to close the window
6
SW USB Pro Series • Internal Web Page
screen opens.
Network Settings
) — To set any of these addresses, click
5
).
1
32