Others; Faq; Safety Precautions - Shining 3D Transcan C User Manual

13.

Others

13.1. FAQ

1. What if no scan data when the turntable has rotated one circle?
Solution: Please make sure that the object won't block the mark points on the turntable. Or there will
be no fringe pattern, while turntable will be still rotating. If the align mode is mark point, please make
sure that the marks on the turntable are covered, so as not to affect the scanning. Make sure that in
each single scan area has at least 4 points.
2. What if the alignment fails without markers when the turntable has rotated several circles?
Solution: Try to make sure there are at least 1/3 overlap between the current scan area and the
previous scan area and the object surface should be featured. For objects which are symmetric and
without rich features, using mark points or manual merger is recommended.
3. How to scan objects in transparent, semi-transparent or black?
Solution: Scan before spraying on the surface.
4. If the turntable is not moving, but with a humming sound, how to solve?
Solution: Disconnect power line and connect again in few seconds.

13.2. Safety Precautions


Keep well-ventilation. Environment temperature shall below 40 Celsius degrees, and do not use
the device under an environment with flammable or corrosive gases or another similar
environment.

Please grab and place gently in the proper position, and do not squeeze it. Prepare precautions
like sunscreen, rain-proof, shock-proof and etc. No matter on sunny or rainy days.

If the device could not function correctly, fixing the device by opening it by yourself is not
allowed. The device shall be repaired by professional technicians or under their instruction.

You should send the device to facilities with qualification for recycling it instead of dropping into
the household garbage when it is scrapped.
Shining 3D Transcan C_User Manual_V1.4.1 60