Positioning Using Batch Setting Method; 12.4.1 Setting Using Gx Developer - Mitsubishi MELSEC-F FX3U Series User Manual

FX /FX Series PLC User's Manual - Positioning Control Edition
3U 3UC
Built-in Positioning Function
12.4

Positioning Using Batch Setting Method

Positioning operation will be performed using the absolute positioning method as shown in the following chart:

12.4.1 Setting Using GX Developer

This section describes how to set the positioning parameters using GX Developer of Ver.8.23Z.
1
On the project tree displayed on the left side of the screen, double-click
"Parameter" and then "PLC parameter".
If the project tree is not displayed on the screen, click "View" on the menu bar, and then click "Project Data List".
2
Click "Memory Capacity", and then enter a check in "Positioning Instruction
settings" check box.
Enter a check.
*1. 9,000 steps are needed to set the positioning data. If there is not enough capacity for programming,
set "memory capacity" to 16,000 steps.
→ For details on input/output assignment, refer to Section 12.1
Output pulse frequency:
100,000 Hz
100
Origin
Acceleration/deceleration time:
*1
12.4 Positioning Using Batch Setting Method
500,000
100 ms
12 Examples of Programs
B - 147
A
B
Apx.