Positioning Parameter Setting; 11.4.1 Positioning Parameter Setting Using Gx Developer - Mitsubishi MELSEC-F FX3U Series User Manual

FX /FX Series PLC User's Manual - Positioning Control Edition
3U 3UC
Built-in Positioning Function
11.4

Positioning Parameter Setting

Use GX Developer of Ver.8.23Z or later to set the positioning parameters.
"Number of pulses" and "frequency" set by positioning parameters in a positioning table can be changed
using the program, display module, or indicator.

11.4.1 Positioning Parameter Setting Using GX Developer

Assuming that GX Developer of Ver.8.23Z is used, this section describes how to set the positioning
parameter.
1
Open "parameter setting" window.
On the project tree displayed on the left side of the screen, double-click "Parameter" and then "PLC
Parameter".
If the project tree is not displayed, click "View" on the menu bar, and then click "Project data list"
B - 130
→ To change the set "number of pulses" or "frequency", refer to Subsection 11.4.2.
11 Batch Data Positioning Mode (TBL Instruction)
11.4 Positioning Parameter Setting