Designation Of Interrupt Input Signal For Dvit Instruction - Mitsubishi MELSEC-F FX3U Series User Manual

FX /FX Series PLC User's Manual - Positioning Control Edition
3U 3UC
Built-in Positioning Function
4.3.7

Designation of interrupt input Signal for DVIT Instruction

The interrupt input signal of the interrupt positioning (DVIT) instruction depends on the pulse output
destination device as shown in the following table.
Use the FX
3UC
Use the FX /FX
3U
Pulse output
destination
device
Y000
Y001
Y002
*1
Y003
*1. Devices related to Y003 (pulse output destination) are valid only if two FX
connected to the FX
Designation of interrupt input using M8336:
1) Turn on the M8336.
2) Set the interrupt input number (X000 to X007) in the D8336, or
specify the user interruption command device
D8336=H
Setting value
0
1
7
*1
8
*3
9 to E
F *3
B - 40
PLC of Ver. 1.30 or later to specify the interrupt input signal.
PLC of Ver. 2.00 or later to set the user interruption command device.
3UC
If it is not necessary to use the
interrupt input designation function
(M8336 = OFF), or if the FX
below Ver. 1.30 is used
X000
X001
X002
X003
PLC.
3U
→ For example of specifying program, refer to the following description.
Interrupt input for Y000
(pulse output destination device)
Interrupt input for Y001
(pulse output destination device)
Interrupt input for Y002
(pulse output destination device)
Interrupt input for Y003
(pulse output destination device)
Specifies X000 for the interrupt input signal.
Specifies X001 for the interrupt input signal.
Specifies X007 for the interrupt input signal.
Specifies the user interruption command device
Pulse output destination device User interruption command device
Y000
Y001
Y002
Y003
Do not specify these values.
Set "F" for a pulse output destination device if the device is not used for the interrupt
positioning (DVIT) instruction.
→ For operation of DVIT instruction, refer to Chapter 9.
Interrupt input signal
If it is necessary to use the interrupt input designation
PLC of
3UC
D8336=H
*1
.
Description of setting
*1
*2
4 Before Programming
4.3 Various Flags for Operation Commands
function (M8336 = ON)
Interrupt input for Y000
(pulse output destination device)
Interrupt input for Y001
(pulse output destination device)
Interrupt input for Y002
(pulse output destination device)
Interrupt input for Y003
(pulse output destination device)
-2HSY-ADP adapters are
3U
for the interrupt input signal.
M8460
M8461
M8462
M8463