European Terminal Board; Cable; Termination Of Cable End; Tool - Mitsubishi MELSEC-F FX3U Series User Manual

FX /FX Series PLC User's Manual - Positioning Control Edition
3U 3UC
Built-in Positioning Function
• When two wires are connected to one terminal
6.8mm(0.27")
or less
6.8mm(0.27")
or less
3.2

European Terminal Board

The European terminal board is adopted for the high-speed output special adapter and the FX
input/output extension block.
3.2.1

Cable

Applicable cables and tightening torques
Wire size (stranded/single wire)
Single-wire 0.3 mm
2-wires
0.3 mm
Rod
0.3 mm
terminal
(Refer to the external view of rod
with
terminal shown in the following
insulation
figure.)
sleeve
3.2.2

Termination of Cable End

Directly terminate the end of each stranded cable or single-wire cable without a tool, or use the rod terminal
with insulation sleeve for termination.
• Directly terminate end of stranded/single-wire cable:
- Terminate the end of the stranded cable so that "barbed wires"
cannot protrude.
- Do not solder-plate the end of the cable.
• Terminate cable end using rod terminal with insulation sleeve:
If the cable sheath is too thick, it may be difficult to insert the cable
into the insulation sleeve. For this reason, select an appropriate cable
while referring to the external view.
Manufacturer
Phoenix Contact
3.2.3

Tool

• To tighten terminals, use a purchased small-sized screwdriver whose tip
is straight and is not widened as shown in the right figure.
Manufacturer
Phoenix Contact
B - 24
φ 3.7(0.15")
6.0mm(0.24")
or more
φ 3.7(0.15")
6.0mm(0.24")
or more
2 2
to 0.5 mm (AWG22 to 20)
2
(AWG22)
2 2
to 0.5 mm (AWG22-20)
Model
AI 0.5-8WH
3 Connection of Input/Output Lines and Tightening
Terminal
screw
Terminal
Tightening
torque
• To connect a stranded cable, peel the sheath off the
cable, and then twist the core before connection.
• To connect a single-wire cable, just peel the sheath
off the cable before connection.
0.22 to
• Rod terminal with insulation sleeve
0.25 N m
•
(recommended terminal):AI 0.5-8WH
(Manufactured by Phoenix Contact)
• Caulking tool:
CRIMPFOX UD6 (Manufactured by Phoenix Contact)
Caulking tool
CRIMPFOX UD6
Model
SZS 0.4×2.5
3.2 European Terminal Board
Crimp
terminal
Series
2NC
Termination
• Stranded wire/solid wire
9mm
(0.36")
• Bar terminal with insulating sleeve
Insulating sleeve
Contact portion
8mm
(0.32")
2.6mm
(0.11")
14mm(0.56")
With
straight tip
0.4mm 2.5mm
(0.02") (0.1")