Connector; Cable Connection To Input/Output Connector; Setup Of Input/Output Connection Connector - Mitsubishi MELSEC-F FX3U Series User Manual

FX /FX Series PLC User's Manual - Positioning Control Edition
3U 3UC
Built-in Positioning Function
3.3

Connector

Connectors conforming to the requirements of the MIL C-83503 are adopted for the FX
and some types of FX
3.3.1

Cable Connection To Input/Output Connector

Prepare the input/output cables while referring to the next page.
3.3.2

Setup of Input/Output Connection Connector

1. Applicable connector (connector purchased at store)
Use a 20-pin (1-key) socket that conforms to the requirements of the MIL C-83503.
Preliminarily check that the peripheral parts, such as the connector cover, will not cause any interference.
2. Input/output cables (optional cables manufactured by our company)
Our company can provide input/output cables already equipped with a connector.
Model
FX-16E-500CAB-S
FX-16E-150CAB
FX-16E-300CAB
FX-16E-500CAB
FX-16E-150CAB-R
FX-16E-300CAB-R
FX-16E-500CAB-R
FX-A32E-150CAB
FX-A32E-300CAB
FX-A32E-500CAB
Series input/output extension blocks.
2NC
Input: X Output: Y
Length Description
5m
General-purpose input/output cable
(16' 4")
1.5m
(4'11")
3m
(9'10") Cable for connection of FX Series
terminal block to input/output connector
5m
For details of connection to the FX
(16' 4")
Series terminal block, refer to the
1.5m
following manuals:
(4'11")
→FX
3m →FX
(9'10")
5m
(16' 4")
1.5m
(4'11")
Cable for connection of A Series
3m
A6TBXY36 connector/terminal board
(9'10")
conversion unit to input/output
connector type
5m
(16' 4")
3 Connection of Input/Output Lines and Tightening
Input
X0 X10
X1 X11
X2 X12
X3 X13
X4 X14
X5 X15
X6 X16
X7 X17
COM COM
*1 *1
*1: "•" means that the terminal is not used.
The 20-pin connector is attached to
one end of the non-stranded cable.
(Green, red)
The 20-pin connector is attached to
both end of the flat cable (with tube).
Hardware Edition
3U
The 20-pin connector is attached to
Hardware Edition
3UC
both ends of the round multi-core
cable.
Two 20-pin connectors (unit: 16
points) are attached to the PLC side
of the flat cable (with tube), and the
dedicated connector is attached to
the terminal board side of the flat
cable. (32 points for each input/
output common)
3.3 Connector
Series main unit
3UC
Output
Y0 Y10
Y1 Y11
Y2 Y12
Y3 Y13
Y4 Y14
Y5 Y15
Y6 Y16
Y7 Y17
COM1 COM1
*1 *1
Connector type
B - 25
A
B
Apx.