Nmi Functionality - HPE Apollo 4200 Gen10 Maintenance And Service Manual

Table of Contents

Position

Default

Off

—

S10

—

S11

—

S12

—

To access the redundant ROM, set S1, S5, and S6 to On.

When the system maintenance switch position 6 is set to the On position, the system is prepared to restore all configuration settings to their

manufacturing defaults.

When the system maintenance switch position 6 is set to the On position and Secure Boot is enabled, some configurations cannot be

restored. For more information, see Secure Boot.

Disabling the HPE Smart Array S100i Controller

Before changing the boot mode to Legacy BIOS Mode, you must first disable the HPE Smart Array S100i Controller.

NOTE: When you use the software to update, maintain, or monitor the HPE Apollo 4200 Gen10 system, you will see HPE

ProLiant XL420 Gen10 Server as the product name in the interface.

Procedure

1. Reboot the system.

The system restarts and the POST screen appears.

2. Press F9.

The System Utilities screen appears.

3. Select System Configuration > BIOS/Platform Configuration (RBSU) > System Options > SATA Controller Options >

Embedded SATA Configuration, and then press Enter.

4. Select Enable SATA AHCI Support, and then press Enter.

5. To save the selection, press F10.

6. To save the changes, press Y.

The Change saved confirmation prompt appears.

7. Select Exit and resume system boot, and press Enter.

The system continues the normal boot process.

For more information, see the product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).