Procedure
1. Power down the system (Power down the system).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the system.
3. Remove the system from the rack (Remove the system from the rack).
4. Place the system on a flat, level surface.
5. Remove the access panel (Remove the access panel).
6. If you are removing an expansion board or controller installed in the PCI riser cage, remove the riser cage.
7. Disconnect any cables that are connected to the expansion board or controller.
8. Remove the expansion board or controller.
•
Expansion board/controller removal from an onboard expansion slot
•
Expansion board/controller removal from the PCI riser cage
To replace the component, reverse the procedure.
Removal and replacement procedures
72