HPE Apollo 4200 Gen10 Maintenance And Service Manual page 82

Two drives of the same physical size, or one of each size (80mm and 110mm), can be installed at the same time. Depending on
the replacement drive model, you might be required to relocate the M.2 drive retaining latches on the boot device.
Prerequisites
Review the boot device drive bay LEDs to determine the failed drive.
Procedure
1. Observe the following alerts:
CAUTION: The boot device and the drives installed on the boot device are not hot-pluggable. To remove the boot
device, or a drive from the boot device, you must first power down the server.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
2.
Back up all system data.
3.
Power down the system.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the system.
5.
Do one of the following:
Extend the front drive cages out of the chassis.
•
• Remove the system from the rack.
• Remove the compute module from the enclosure.
6.
Place the system on a flat, level work surface.
7. Remove the access panel.
8. Remove the PCIe riser cage.
9. Remove the boot device.
10. Remove the failed drive from the boot device.
Removal and replacement procedures
82