Table of Contents
Advertisement
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the system.
3. Remove the system from the rack (Remove the system from the rack).
4. Place the system on a flat, level surface.
5. Remove the access panel (Remove the access panel).
6. Remove the air baffle on the rear of the NVMe drive cage.
To replace the component, reverse the removal procedure.
Removing and replacing a rear NVMe drive cage fan
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
•
The components included with the hardware kit
•
Torx T-15 screwdriver
Procedure
1. Power down the system (Power down the system).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the system.
3. Remove the system from the rack (Remove the system from the rack).
4. Place the system on a flat, level surface.
5. Remove the access panel (Remove the access panel).
Removal and replacement procedures
62
Advertisement
Table of Contents
