To replace the SFF drive blank, while pressing the release latch, slide the component into the bay until it is fully seated.
Removing and replacing a drive blank from the rear drive cage
CAUTION: Do not operate the system with any of the rear drive bays empty. To maintain proper airflow and sufficient
cooling in the rear drive cage, all drive bays in this cage must have a drive or a drive blank. Hewlett Packard Enterprise
recommends installing at least one drive in the rear drive cage before operating the system.
Procedure
1. Access the product rear panel.
2. Remove the drive blank:
•
LFF drive blank
To replace the LFF drive blank, slide the component into the bay until it clicks.
•
SFF drive blank
Removal and replacement procedures
48