Remove The Hpe Smart Storage Battery - HPE Apollo 4200 Gen10 Maintenance And Service Manual

6. Extend the front drive cages out of the chassis (Extend the front drive cages out of the chassis).
7. Press and hold the cable management holder release latch, and then open the holder.
8. Remove the cables from the cable management holder.

Remove the HPE Smart Storage Battery

NOTE: System ROM and firmware messages might display "energy pack" in place of "Smart Storage Battery." Energy pack
refers to both HPE Smart Storage batteries and HPE Smart Storage Hybrid capacitors.
Procedure
1. Power down the system (Power down the system).
2. Remove the system from the rack (Remove the system from the rack).
3. Place the system on a flat, level work surface.
4. Remove the access panel (Remove the access panel).
5. Extend the front drive cages out of the chassis (Extend the front drive cages out of the chassis).
6. Open the cable management holder, and then remove the cables from the cable management holder (Open the cable
management holder).
7. Disconnect the cable from the system board.
45
Removal and replacement procedures