Table of Contents
Advertisement
WARNING: To reduce the risk of personal injury or damage to the equipment, adequately stabilize the rack before
extending a component outside the rack. Extend only one component at a time. A rack may become unstable if more
than one component is extended.
CAUTION: Do not operate the system for long periods with the front drive cages extended. When the front drive
cages are extended while the system is powered on, monitor the status of the front drive temp sensor (08-HD Max)
in iLO. If the iLO temp sensor (08-HD Max) reading is reporting an N/A value, monitor how long the drive cages have
been out of the chassis. Before reaching the 110 second mark, slide the drive cages back into the chassis and keep
them there for at least 300 seconds before extending them again.
Failure to observe this caution will result in improper airflow and insufficient cooling that can lead to thermal
damage.
3. Extend the front drive cages by pulling down on the front drive cage release latches and extending the front and internal
drive cages out of the chassis.
37
Removal and replacement procedures
Advertisement
Table of Contents
