Table of Contents
Advertisement
JUPITER-(3000K, 6000K, 9000K)-H1 Smart
Transformer Station
User Manual
Figure 6-58 Removing the measurement and control module
Step 7 Install a new measurement and control module in the original position.
Step 8 Reinstall the bracket above the measurement and control module. Use an M6
Phillips screwdriver and tighten the screws to a torque of 5 N·m.
Step 9 Secure the new measurement and control module to the bracket. Use an M4
Phillips screwdriver and tighten the screws to a torque of 1.2 N·m.
Step 10 Reinstall the PSU and positioning kit. Use an M6 Phillips screwdriver and tighten
the screws to a torque of 5 N·m.
Step 11 Reconnect the cables to the new measurement and control module based on the
cable connection records.
Step 12 Reinstall the cable boxes on both sides of the measurement and control module.
Use an M6 Phillips screwdriver and tighten the screws to a torque of 5 N·m.
Step 13 Power on the measurement and control module in the reverse order of the power-
off operations.
----End
Issue 02 (2023-09-30)
Copyright © Huawei Technologies Co., Ltd.
6 System Maintenance
192
Advertisement
Table of Contents
