Table of Contents
Advertisement
JUPITER-(3000K, 6000K, 9000K)-H1 Smart
Transformer Station
User Manual
Figure 6-53 Removing a main control module
Step 4 Install a new main control module in the original position. Use an M4 Phillips
screwdriver and tighten the screws to a torque of 1.2 N·m.
Step 5 Reconnect the cables to the new main control module based on the cable
connection records.
Step 6 Reinstall the sealing plate of LV PANEL A.
----End
Follow-up Procedure
Step 1 Turn on 1FB3.
Step 2 Log in to the SmartLogger to check that the communication is normal and that no
related alarm is generated.
Step 3 Check the running status of the system and ensure that the functions are restored.
Step 4 (Optional) If the configuration file has been backed up before the device
replacement, log in to the SmartLogger and import the backup configuration file
to the new device. Otherwise, skip this step.
1.
Step 5 (Optional) If the configuration file is not backed up before the device replacement,
set the STS running parameters as follows.
Issue 02 (2023-09-30)
Choose Monitoring > STS > Sync to synchronize the configuration file.
Figure 6-54 Configuration file synchronization
Copyright © Huawei Technologies Co., Ltd.
6 System Maintenance
182
Advertisement
Table of Contents
