Snmp Trap Manager Configuration; Figure 4-11 Snmp Trap Manager Configuration Screen - Zhone 100 User Manual

4 Operation
SNMP Trap
Manager
Configuration

*********************** SNMP Trap Manager Configuration ************************

Name: F@43802
Mgr ------ IP Address ----- ---------------- Name ---------------- ---- Path ---
#1 [T1=]:0.0.0.0
#2 [T2=]:0.0.0.0
#3 [T3=]:0.0.0.0
#4 [T4=]:0.0.0.0
#5 [T5=]:0.0.0.0
#6 [T6=]:0.0.0.0
NOTE: Each Name & IP entry must be made individually.
Disable Traps [B=] ([B=m,n,...r] and/or [B=m-n] for multiple disables)
>> 1)Authen Fail<<
2)CSU LineFail
3)CSU Thresh
4)CSU Failure
5)LMI NetwFail
6)LMI UserFail
Help[?]
>
4-22
The SNMP Trap Manager Configuration screen allows you to view and alter parame-
ters for the SNMP Trap Manager operations.
The SNMP Trap Manager Configuration screen is shown in Figure 4-11.
[N1=]:
[N2=]:
[N3=]:
[N4=]:
[N5=]:
[N6=]:
7)Netw Thresh
8)User Thresh
9)DTR Loss
10)DtePowerLoss
11)Modem Fail
12)DialLineFail
Clear Holdoff [H=#]: 5
1 thru 15 minutes
Save[SA] Cancel[X]

Figure 4-11 SNMP Trap Manager Configuration Screen

Occurrences of any Traps (unless disabled), will be sent to all Trap Managers defined,
including Traps sent Out-of-Band (dial-out) using the NetPath 100 internal modem.
Out-of-Band Traps, however, will only be sent provided the modem is not already in
use when the trap occurs.
1. Mgr # n (1-6) - Parameters to be selected for each Trap Manager are as follows:
Each Trap Manager defined will be sent a copy of each Trap (alarm) that occurs.
The Loss-of-Power (cry-for-help) Trap will only be sent to the First
Trap Manager defined. This Trap Manager should be defined with
a WAN or Payload IP Address to ensure receipt of this trap. A CPE
IP Address defined Trap Manager will probably not receive this
Trap, due to this message passing through other CPE
equipment affected by the loss-of-power.
IP Add - Sets the IP Address for each Trap Manager designated to receive Traps.
Name - 32-character string that identifies the Trap Manager.
Path - Selects WAN (W) or Payload/CPE (P) as the management path for sending
traps to the corresponding Trap Manager.
NetPath 100 User's Manual - Installation Guide
13)ContactSense 19)ISDN Backup
14)BECN/FECN 20)ISDN Demand
15)IsdnAdptFail 21)PVCDrpdThres
16)IsdnLineFail 22)PVCDlvdThres
17)PVCDly Thresh 23)PVCAvailable
18)Login Fail 24)PVCUnavail
Terminate Delay [D=#]: 45
1 thru 120 seconds
CAUTION
[P1=WorP]:WAN
[P2=WorP]:WAN
[P3=WorP]:WAN
[P4=WorP]:P/C
[P5=WorP]:P/C
[P6=WorP]:P/C
980-001-0210G
June 1999