Connections; Figure 3-10 Netpath 100 Rear Panel (Basic); Table 3-1 Basic Netpath 100 Input/Output Connectors And Control Specifications - Zhone 100 User Manual

Connections

90-250 V AC
.5A
50-60 Hz
FUSE
2A/250V
SLOW BLOW
5x20m m
"CAUTIO N"
FO R C ON T INU ED PR OT EC T ION AG AINST RISK O F FIR E,
R EPLAC E ON LY W IT H SAM E T YPE AND RAT IN G OF FU SE.

Table 3-1 Basic NetPath 100 Input/Output Connectors and Control Specifications

Connectors
Power Connector
Control Output
Data Port
AUX 1, AUX 2
NVM Reset/Config
T1 Line
Modem Line (Analog)
DIP Switches
980-001-0210G
June 1999
NetPath 100 has connectors on the rear panel for power and input/output connections.
Rear panel connectors and controls are shown and described in Figure 3-10 and
Table 3-1.
O 1 2 3 4 5 6 7 8 9 1 0 1 11 2 O 1 2
N N
CO NTROL
CO NFIG URATION
O UTPUT

Figure 3-10 NetPath 100 Rear Panel (Basic)

Internal Power Supply with IEC 320 power cord.
4-pin keyed connector to control Model 467 Power Control Unit.
DB-44, high-density connectors provide the following interfaces,
selected by the interface cable used:
EIA-530
EIA-530-A
ITU-V.35
ITU-X.21-NS (Non-Switched)
8-pin modular connectors, EIA-232
Recessed push button that causes the unit's NVM to be cleared if pressed and held
(approximately four seconds) during the unit's power-up self-test.
8-pin modular connector, RJ48C
6-pin modular connector, RJ11C
One 2-position and one 12-position DIP switch for the initial setting of the DLCI
address, the DS0 configuration for the T1 link, and the CSU/DTE parameters.
NetPath 100 User's Manual - Installation Guide
DATA PO RT
AUX 1 AUX 2
Description
3 Installation
NVM
RESE T
T1 M ODEM
CO NFIG
LINE LINE
3-3