Zhone 100 User Manual page 135

980-001-0210G
June 1999
ISDN Backup - Displays current status as reported by ISDN Adapter module.
Status states are:
ISDN Adp Fault - The ISDN hardware has failed (backup cannot
be accomplished).
Primary Online - Backup connection in place using Primary Dials.
Secondary Online - Backup connection in place using Secondary Dials.
Primary DwnSpd - Backup connection in place using Primary Dials, but
with fewer ISDN connections than configured for.
Secondary DwnSpd - Backup connection in place using Secondary
Dials, but with fewer ISDN connections than configured for.
Connecting - Connection is being established.
Failed - Retry attempts exhausted.
ISDN Line Failure - The ISDN line of at least one B-Channel is faulty
(backup may not be possible).
ISDN SPID Failure - An invalid or incorrect SPID has been entered for at
least one B-Channel (backup may not be possible).
B1 SPID Failure - A B2-Channel cannot operate due to a SPID failure
on its associated B1-Channel.
Service Disabled - "Service Disable" has been selected on the
"ISDN Status / Test" screen.
Time Disabled - "Time Disable" has been selected on the
"ISDN Status / Test" screen.
LoopUp - LoopUp connection in place.
Armed - Default state if not disabled and no failure exists.
Demand Setup - Selects the current state for demand operations.
Reset/Arm - Terminates any current activity and clears any Failed condition so
that automatic demand initiation may occur. This is the default state.
Call Out/Loop - Initiates Bandwidth On-Demand (BOD) call-out and sets a loop-
back toward the Network at the On-Demand configured data rate.
If configured for ML-PPP inverse multiplexing, the user will be prompt-
ed to enter the following items:
User Name
User Password
Network IP Address
User IP Address
After entering all the items, they will be displayed on the screen as shown
in Figure 6-8 above.
Loop to User - Loops data back toward the User at the ISDN Data Port. If a Band-
width On-Demand call is active, it will be terminated before the loopback
is established.
NetPath 100 User's Manual - Installation Guide
6 Options
6-19