Cisco Hd-60 Adapter Cable Specifications; Table 3-13 Cisco Hd-60M To Netpath 100 Hd-44M - Zhone 100 User Manual

Cisco HD-60
Adapter Cable
Specifications
980-001-0210G
June 1999
To connect a Cisco* router to a NetPath 100 Data Port configured for ITU-V.35, use
CRC cable assembly # 135-006-0400, or per pinout shown in Table 3-13.

Table 3-13 Cisco HD-60M to NetPath 100 HD-44M

Cisco
DB-44M
HD-60M
Pin
Pin
Shield Shield
17 32
18 17
19 44
20 29
23 40
24 25
25 42
26 27
NOTES:
Shielded cable is required.
Twisted Pair cable conductors for HD-60 pins: 17 & 18, 19 & 20, 21 & 22,
23 & 24, 25 & 26, 27 & 28, 33 & 34, 35 & 42, 43, & 44, 45 & 46.
HD-60 pins tied: 48 to 49, 50 to 51 to 52, 53 to 54 to 55 to 56.
HD-44 pins tied: 17 to 37 via resistor, 32 to 37 via resistor,
22 to 28 to 30, then all to 29 via resistor,
22 to 28 to 30, then all to 44 via resistor
(Resistor = 300 Ohm, 1/4 W, 5%).
(s) = single ended.
* Cisco is a registered trademark of Cisco Systems, Inc.
NetPath 100 User's Manual - Installation Guide
Cisco
Signal HD-60M
Pin
Shield 27
TD-B 28
TD-A 33
TCE-B 34
TCE-A 35
TC-B 42
TC-A 43
RC-B 45
RC-A 46
3 Installation
DB-44M
Signal
Pin
33 RD-B
18 RD-A
8 DCD(s)
6 DSR(s)
5 CTS(s)
4 RTS(s)
9 DTR(s)
7 Sig. Gnd.
1 Shield
3-17