Table of Contents
Advertisement
1 Preface
FCC Part 68
(U.S.)
1-4
This equipment complies with Part 68 of the FCC Rules. On the underside of this
equipment is a label that contains, among other information, the FCC registration num-
ber and Ringer Equivalence Number (REN) for this equipment. If requested, this in-
formation must be provided to the telephone company.
This equipment uses the following USOC jacks: RJ11C, RJ48C and RJ49C (optional).
This equipment is designed to be connected to the telephone network using compatible
modular plugs which are Part 68 compliant. See installation instructions for details.
The REN is used to determine the quantity of devices which may be connected to the
telephone line. Excessive RENs on the telephone line may result in the devices not
ringing in response to an incoming call. In most, but not all areas, the sum of RENs
should not exceed five (5.0). To be certain of the number of devices that may be con-
nected to a line, as determined by the total RENs, contact the local telephone company.
If the NetPath 100 equipment causes harm to the telephone network, the telephone
company will notify you in advance that temporary discontinuance of service may be
required. But if advance notice isn't practical, the telephone company will notify the
customer as soon as possible. Also, you will be advised of your right to file a complaint
with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations or
procedures that could affect the operation of the equipment. If this happens the tele-
phone company will provide advance notice in order for you to make necessary mod-
ifications to maintain uninterrupted service.
If trouble is experienced with this NetPath 100 equipment, for repair or warranty in-
formation, please contact Control Resources Corporation, 16-00 Pollitt Drive, Fair
Lawn, New Jersey 07410, (201) 703-4800. If the equipment is causing harm to the tele-
phone network, the telephone company may request that you disconnect the equipment
until the problem is resolved.
There are no user-replaceable parts that may be serviced inside the NetPath 100.
This equipment cannot be used on public coin phone service provided by the telephone
company. Connection to party line service is subject to state tariffs. (Contact the state
public utility commission, public service commission or corporation commission for
information.)
Table 1-1 FCC Registration Information
Port
Modem Line
02LS2
(Dial Line)
T1 Line with
04DU9-B
D4 Framing
T1 Line with
04DU9-C
ESF Framing
T1 Line with
04DU9-S
ESF Framing
B8ZS Line Code
ISDN Line
02IS5
NetPath 100 User's Manual - Installation Guide
FIC
SOC
9.0Y
6.0N
6.0N
6.0N
6.0Y
Network
REN
USOC
0.7B
RJ11C
---
RJ48C
---
RJ48C
---
RJ48C
---
RJ49C
980-001-0210G
June 1999
Advertisement
Table of Contents
Troubleshooting
