Zhone 100 User Manual page 136

6 Options
6-20
On - Demand Interface Status - Displays current state or activity for the interface.
DTR: State of DTR lead, ON or OFF.
RTS: State of RTS lead, ON or OFF.
ISDN Demand: Displays current status as reported by ISDN Adapter module.
Status states are:
ISDN Adp Fault - The ISDN hardware has failed (call cannot be
accomplished).
Primary Online - On-Demand connection in place using Primary Dial
number(s).
Secondary Online - On-Demand connection in place using Secondary
Dial number(s).
Primary DwnSpd - On-Demand connection in place using Primary Dial
number(s), but with fewer ISDN B-Channels than specified in
configuration.
Secondary DwnSpd - On-Demand connection in place using
Secondary Dials number(s), but with fewer ISDN B-Channels
than specified in configuration.
Connecting - Connection is being established.
Failed - Retry attempts exhausted.
ISDN Line Failure - The ISDN line of at least one B-Channel is faulty
(call may not be possible).
ISDN SPID Failure - An invalid or incorrect SPID has been entered for at
least one B-Channel (call may not be possible).
B1 SPID Failure - A B2-Channel cannot operate due to a SPID failure
on its associated B1-Channel.
Armed - Default state if not disabled and no failure exists.
Line n / Bn: Displays current status of each ISDN line and B Channel.
Status states are:
ISDN Adp Fault - The ISDN hardware has failed.
ISDN Line Failure - The ISDN line of this B-Channel is faulty.
ISDN SPID Failure - An invalid or incorrect SPID has been entered for
this B-Channel.
B1 SPID Failure - A B2-Channel cannot operate due to a SPID failure
on its associated B1-Channel.
LoopUp - LoopUp connection in place.
Connecting - Connection is being established.
Online - Connection in place.
Ready-xxx(-mmmm) - Default state if not disabled and no failure exists.
"xxx" indicates the latest Cause Code (See NOTE below.)
"mmmm" indicates the last connection status, see Table 6-5
for codes (applies to ML-PPP inverse multiplexing ONLY.)
Failed-xxx(-mmmm) - Retry attempts exhausted.
"xxx" indicates the latest Cause Code (See Note below.)
"mmmm" indicates the last connection status, see Table 6-5
for codes (applies to ML-PPP inverse multiplexing ONLY.)
NOTE: An ISDN switch will return a "Cause Code" indicating a status for the latest
connection attempt. A "Ready" or "Failed" status and the latest returned code
number are displayed in this field for each configured B-Channel. A list of
codes and causes are shown in Table 6-4.
NetPath 100 User's Manual - Installation Guide 980-001-0210G
June 1999