Zhone 100 User Manual page 134

6 Options
6-18
Test Status - Displays currently active tests. States are: Lp to User,
2047 Payld to User, Line Lp to Netw, Payld Lp to Netw, QRSS to Netw,
Alt Ones to Netw, 2047 Payld to Netw, Test Pkts to Netw, or (blank) if none.
Refer to Device Status / Test screen description in section 5 Diagnostics of this
manual for detailed descriptions of these tests.
Backup Setup - Selects the current state for backup operations.
Selections are as follows:
Reset/Arm - Terminates any current activity and clears any Failed or Disabled
conditions so that automatic backup initiation may occur. This is the
default state.
Activate -Initiates backup connection process.
Service Disable -Terminates and/or disables all backup activity to prevent
initiation of undesired backup while preforming service activity. Disable
is automatically released to the Reset/Arm state after 15 continuous
minutes of no service activity detected (service activity is indicated by
the existence of fault conditions or tests such as Red Alarm, Line
Loopback, etc.).
Time Disable - Terminates and/or disables all backup activity for the specified
period of time. When selected, a prompt is displayed to select the time
period (1 to 72 hours). After valid time period is entered, the "Duration"
field is displayed, showing the time remaining before Disable is
released to the Reset/Arm state.
High Speed Interface Status -
DTR: State of DTR lead, when Power is being detected from the DTE.
States are: ON, OFF or (blank) if Power OFF.
RTS: State of RTS lead, when Power is being detected from the DTE.
States are: ON, OFF or (blank) if Power OFF.
Power: ON or OFF based on sensing voltage on Tx data lead(s) from the DTE.
NetPath 100 User's Manual - Installation Guide 980-001-0210G
June 1999