Frame Manager Configuration; Figure 4-9 Frame Manager Configuration Screen - Zhone 100 User Manual

4 Operation
Frame Manager
Configuration

************************** Frame Manager Configuration *************************

Name: F@43802
WAN Mgmt DLCI [D=#orT#]: Disabled
P/C Mgmt DLCI [E=P#orC#]: Disabled
X to Disable or 16 thru 991
------------- Network ------------
T391/Status Enq Rate [S1=#]: 10
5 thru 30 seconds
N392/Event Err Thres [T1=#]: 3
N393/Event Count [C1=#]: 4
1 thru 10
N391/Full Status Freq [F1=#]: 6
1 thru 255
PVC BECN/FECN Thres [B=#]: Disabled
X to Disable or 1 thru 895 seconds
Link Err Thres [L1=#]: Disabled
X to Disable or 1 thru 895 seconds
Help[?]
>
4-18
The Frame Manager Configuration screen allows you to view and alter parameters for
Frame Manager operations.
The Frame Manager Configuration screen is shown in Figure 4-9.
Save[SA] Cancel[X]

Figure 4-9 Frame Manager Configuration Screen

Configure Frame Manager
1. WAN Mgmt DLCI - Displays current DLCI value of the private network PVC or
Tunneled PVC for WAN management of the NetPath 100, as stored in the unit's
non-volatile memory (NVM). This value may be entered using the unit's rear
panel DLCI DIP Switches, or entered from this screen. Enter only DLCI number
for private network PVC, or preface DLCI number with "T" for tunneled PVC.
2. P/C Mgmt DLCI - Sets or disables the direction and PVC for Payload/CPE
management access to the NetPath 100. The first letter (P or C) determines which
direction, and the remainder indicates the DLCI value.
NOTE: The P/C Mgmt DLCI value must NOT be the same as WAN Mgmt DLCI.
If either WAN or P/C Mgmt DLCI value is changed, the
NetPath 100 will perform a system reset after the Save
[SA] command is issued. The system reset will terminate
any console session in progress and interrupt data
traffic.
3. LMI Protocol - Displays and allows the selection of the LMI protocol used. If set
to "None," LMI traffic (if any) to or from the Network will be passed through the
NetPath unaffected, and the unit's LMI alarms and status will be cleared.
4. Network (DTE) - Consists of the settings required for the various protocols. These
include T391, N392, N393 and N391.
NetPath 100 User's Manual - Installation Guide
LMI Protocol [P=]
1) None
>>2) ANSI"D" <<
-------------- User --------------
T392/Status Enq Timeout [S2=#]: 15
5 thru 30 seconds
N392/Event Error Thres [T2=#]: 3
N393/Event Count [C2=#]: 4
1 thru 10
Force Full Status Response [F2=]
>>1) Disable<<
2) Enable
Link Err Thres [L2=#]: Disabled
X to Disable or 1 thru 895 seconds
CAUTION
3) "LMI"
4) ITU"A"
980-001-0210G
June 1999