Zhone 100 User Manual page 129

980-001-0210G
June 1999
Learn IP Add - Selects IP Address to "Learning Mode," where unit will learn its
IP Address from the first valid Frame received after connecting. Set to "1" for
learning on "Every Connection." Set to "2" for learning only if "Bkp # n WAN IP
Add" is set to zero.
NOTE: See the next page of this section for detailed description of SNMP IP
Address learning.
On - Demand: Establishes and maintains an ISDN data link(s) for the ISDN Data Port
while the DTE on that port holds DTR High. Does not affect Frame Manager.
Descriptions for Dmd Rtry Count and Dmd Rtry Holdoff configuration items are the
same as the Bkp configuration items described on the previous page.
NOTE: Demand operation is not supported when using an X.21 electrical interface.
Assign to Backup / Demand - Designates which B Channel(s) will be used for
Backup operation and which B Channel(s) will be used for On-Demand operation.
Issuing "B=" or "D=" commands without any parameters deselects all associated
B Channels.
Primary & Secondary Dial #n - Enter the phone numbers to be dialed to estab-
lish a Backup or On-Demand connection. Numeric string (0 - 20 characters).
NOTE: For Bond/M1 IMUX selection, a single connection must be estab-
lished prior to dialing the remaining numbers. The first assigned channel in
the list and its number will be used for the initial call. All other dial numbers
are ignored.
NOTE: For On-Demand ML-PPP IMUX selection, a router LCP Time-Out
of less than 3 minutes may prohibit the dialing of secondary numbers.
Commands
Help [?] - Advances to "Help" for Backup / On-Demand Configuration screen.
Save [SA] - Saves parameters and returns to System View screen.
Cancel [X] - Returns to System View screen without saving changes.
If any parameter on this screen was changed, the ISDN
Adapter will perform a reset after the Save [SA]
command is issued. The reset will interrupt ISDN data
traffic.
Save the Backup / On-Demand Configuration changes when they are all set correctly
by entering "SA" followed by ENTER. This will also return the user to the System
View screen.
NetPath 100 User's Manual - Installation Guide
CAUTION
6 Options
6-13