Optional Power Control Unit Power Connection; Figure 3-12 Power Control Unit Connections - Zhone 100 User Manual

3 Installation
Optional Power
Control Unit Power
Connection
Connect D TE AC Input
NetPath Controlled P ow er
AC O U T
S ocket
AC IN
P lug
3-6
Three connections are required to install an optional Model 467 Power Control Unit.
A. Connect the device to be controlled (usually the DTE connected to the NetPath
100) to the Switched AC OUT Socket (125 VAC) of the Power Control Unit
shown in Figure 3-12 below.
Do not plug the power cord from the NetPath 100 into the
AC OUT socket of the Power Control Unit. This is an
invalid configuration.
B. Connect the Power/Control Cable from the Power Control Unit shown in Figure 3-
12 to the Control Output connector on the rear panel of the NetPath 100 (shown in
Figure 3-11).
C. Verify that the proper voltage is present at the outlet to be used (90 - 125 VAC,
50 - 60 Hz). If the outlet voltage is correct, plug the AC IN Plug from the Power
Control Unit into the AC outlet.
here for
SW ITC HED
AC O U T
125VAC
5A M AX
W ARNING!
NO USER SERVICEABLE PARTS INSIDE
HIG H IN TERNAL VO LTAG ES PRESENT
IN TER NAL SHO CK HAZARD PR ESENT
AC IN
125VAC
5.5 AM PS M AX
50-60Hz
A P-C O M Com pany

Figure 3-12 Power Control Unit Connections

Continue the installation by making Input/Output connections and Configuring the
NetPath 100 as described in the following sections of this manual.
NetPath 100 User's Manual - Installation Guide
CAUTION
SEE
U SERS
M ANU AL
Control O utput C onnector
on N etP ath 100 rear panel
P ow er/Control
Connector
(4-P in, K eyed, Locking)
Connect to
980-001-0210G
June 1999