Changing External Leads - Paradyne COMSPHERE
3610 User Manual

COMSPHERE 3600 Series Data Service Units
To access the Configure branch:
PRESS: 4 – Confg
The Configure Menu Selection screen appears and is
comparable to selecting Confg from the front panel.
Customer ID: ORLANDO2
Configure:
1 – Opts
2 – PList
3 – Dir
4 – Phone
5 – Addr
6 – ChgMd
7 – Term
PRESS Desired Selection Key:

Changing External Leads

The External Leads configuration option must be set
before external leads can be displayed or changed. To set
external leads, select ExtLd from General Configuration
Options (Table 4-4). After External Leads is enabled:
Procedure
1. From the Second-Level Menu screen:
PRESS: 5 – Ctrl
2. The Control Function Menu selection screen
appears.
PRESS: 3 – ExtL
3. The External Leads Menu selection screen
appears.
PRESS: 2 – Chang
C-6
Model: COMSPHERE 3610
T/ C t r l – T = Top Menu
U/ C t r l – U = Up Menu
V/C t r l – V= View H/S
C t r l – x = Disconnect
December 1996
Customer ID: ORLANDO2
External Leads:
1 – Displ
2 – Chang
PRESS Desired Selection Key:
4. The External Leads Input screen appears. The
OutA or OutB field will be highlighted. To
change the value of the bolded field:
PRESS: 1 – Toggle
The highlighted field will change from high to
low or vice versa for on and off. At the front
panel, use the keys instead. To move between
the OutA and OutB fields, use the < Tab> key on
the keyboard. At the front panel, use the
key.
Customer ID: ORLANDO2
OutA:^ OutB:_
1 – Toggle
2 – Save
PRESS Desired Selection Key; <TAB> to go between fields
5. If the value of either field is changed:
PRESS: 2 – Save
Model: COMSPHERE 3610
T/ C t r l – T = Top Menu
U/ C t r l – U = Up Menu
V/C t r l – V = View H/S
C t r l – x = Disconnect
or
Model: COMSPHERE 3610
T/ C t r l – T = Top Menu
U/ C t r l – U = Up Menu
V/C t r l – V =View H/S
C t r l – x = Disconnect
3610-A2-GB46-60