Paradyne COMSPHERE
3610 User Manual page 86

Message
Devic Device Failure. One of the following major alarms is
in effect:
Configuration Corrupt
DSU Device Failure
MUX Device Failure
DialBU Dial BackUp Mode.
DialCN Dial Connect.
DialTn Dial Tone Test failure.
Disab Indicates DSU, DBM, or Port nn is disabled
( nn = 1–6).
DTR DTE alarm.
ExtLd External lead alarm A or B.
Facil DDS facility alarm. Indicates a network facility
alarm.
MAJOR Indicates a major alarm from a DATAPHONE II
device.
MUX MUX (TDM or MCMP) failure.
NoResp No response. The active poll list member did not
respond.
Normal Active poll list member reports no alarm or status.
RPower Redundant power supply alarm.
Stndby Dial standby.
Stream Streaming terminal.
SubSpd Subnormal operating speed.
Test Test mode. DSU test, DBM test, or Port nn test
( nn = 1–6).
Thresh Threshold exceeded.
TribTm Tributary time-out.
Trunc Subtree truncation.
3610-A2-GB46-60
Table E-6
Subnetwork Health and Status Messages
Condition
December 1996
Troubleshooting and Front Panel Messages
Action
See Table E-5 for conditions and action.
Indicates DBM is active.
Indicates DBM is in Standby mode.
Check the DBM facility.
Check status of address.
Data Terminal Ready lead is Off.
See External Alarm A message in Table E-5.
When facility working, remote status address is
available.
Verify DPII connection.
See MCMP or MUX CommunicFail message in
Table E-5.
Probable cause: facility problem, remote DSU
problem, or poll list incorrect.
Status message.
See Redun Pwr Alarm message in Table E-5.
Status message.
See Prt nnn Stream Term message in Table E-5.
See Sub-normal Speed message in Table E-5.
Status message.
See OutofFrame Thresh message in Table E-5.
Multipoint configuration with no response.
See Subtree Truncat message in Table E-5.
E-9