Installation Process; Dsu Installation Planning; Verifying The S1 Switch Settings - Paradyne COMSPHERE
3610 User Manual

COMSPHERE 3600 Series Data Service Units

Installation Process

Verifying the S1 Switch Settings

Powering Up the DSU
Connecting to the DDS Network
Network Verification Testing
DTE Connections

DSU Installation Planning

The Model 3610 DSU is designed for desktop
operation.
Place the DSU in the planned location.
Allow 1 to 2 feet of clearance for cable
connections, space for the ventilation slots on the
sides, and clearance at the rear for the cable
connections.
Verify the S1 switch settings as indicated below.
Verifying the S1 Switch
Settings
HANDLING PRECAUTIONS
FOR
STATIC-SENSITIVE DEVICES
This product is designed to
protect sensitive components
from damage due to electrostatic
discharge (ESD) during normal
operation. When performing
installation procedures, however,
take proper static control
precautions to prevent damage to
equipment. If you are not sure of
the proper static control
precautions, contact your nearest
sales or service representative.
2-2
The Model 3610 DSU has a switch located under the
front panel. To verify or change the S1 switch settings,
remove the front bezel:
Procedure
1. Place a small screwdriver or your thumbs under
the two tabs on the outside edges of the front
bezel. Firmly press upward to separate the bezel
from the tabs.
Front Bezel
2. Swing the front bezel up and set aside.
3. Change the switch settings if necessary. Use a
small instrument. Do not use a pencil.
If the DSU has . . .
Two switches
Four switches
4. Reinsert the front bezel's hinge tabs into position
at the top and swing the bezel down. Snap the
bezel back into place.
December 1996
or
Front Bezel
496-14701-01
Then use . . .
Figure A.
Figure B.
3610-A2-GB46-60