Paradyne COMSPHERE
3610 User Manual page 79

COMSPHERE 3600 Series Data Service Units
Messages Format
The following screen shows the message format.
Command Name
Message
F1 F2
Table E-1
Command Progress Messages
Message
Command Complete Command successfully
completed.
Command Failed Command was not executed.
Please wait . . . Command is taking more than
2 seconds to complete.
Message
Command Failed Command could not execute and none of the
error messages below apply.
Conflict w/Envir Command conflicts with test in progress,
configuration inappropriate for this
command, or configuration option settings
are not compatible.
Inval Selection: Invalid menu selection based upon previous
No Valid Choices selections that caused a menu to display
with no selectable options.
No Response Invalid remote address or remote device not
powered, connected to network, or enabled.
Not in Menu NMS command not in supported set of
commands for NMS.
E-2
F3
Condition
Table E-3
Command Error Messages
Condition
December 1996
Table E-2
Front Panel Messages for
Enabled Async Terminal
Message
User I/F – Idle Async terminal is enabled; the
FP Locked front panel is locked.
User I/F – Activ Async terminal is enabled and a
FP Locked session is started.
Term: Stndby Async terminal is enabled but
inactive. Front panel access has
been initiated and a valid
password entered. The async
terminal is in Standby mode.
If no key is pressed for 5 minutes,
the DSU reverts to User I/F – Idle.
Action
If problem cannot be corrected, call your sales or
service representative.
1. Check for a test in progress.
2. If there is a test in progress, either wait for the
test to finish or abort the test.
3. If there is no test in progress, check
configuration option settings.
Press any key to return to the top-level menu.
Check remote address and status.
Use a valid NMS command.
Condition
3610-A2-GB46-60