Enabling The Async Terminal - Paradyne COMSPHERE
3610 User Manual

Enabling the Async Terminal

To enable the async terminal:
Procedure
1. Ensure that the terminal is connected physically
to the DSU.
2. Go to the Confg branch. Use the
to display the Term selection.
3. Select Term.
4. Select Enab; the following screen appears.
Pswrd:
F1
5. Enter the previously configured password and
press F3. The async terminal is now enabled and
the front panel is disabled (locked). The LCD
displays User I/F – Idle and FP Locked.
If you need to see the password, follow the
Password Security section to access Chang. Press
F1 for Change and the password is displayed.
User I/F – Idle
FP Locked
F1
6. From the terminal, press the Enter key and the
Password Access Menu screen appears.
If the password is valid, the DSU's top-level
menu appears on the async terminal. At the same
time, the LCD's message changes to:
User I/F - Activ
FP Locked
F1
3610-A2-GB46-60
or key
_ _ _ _ _ _ _ _
Enter
F3
F2
F3
F2
F2 F3
December 1996
If no key is pressed at the async terminal for
5 minutes, the front panel redisplays User I/F – Idle
and FP Locked.
If the password is invalid, the Password Access Menu
screen reappears. The async terminal feature is
considered activated when the Top-Level Menu screen
appears (see the Selection Screens section).
Disabling the Async Terminal
To return control of the DSU to the front panel when
async terminal (Term) is enabled:
1. Press the and
three seconds. The following menu appears:
Pswrd:
F1
2. Enter the password characters and select Enter
(F3). If you enter an invalid password, the
following screen appears.
U s e r I / F – I d l e
FP Locked
F1
If a valid password is entered, the front panel
returns to the top-level menu.
Port1
Local
F1
3. Press F1 for Local. Press the
appears; select Confg.
Async Terminal Operation
keys simultaneously for
_ _ _ _ _ _ _ _
Enter
F2 F3
F2 F3
DSU 9.6 C
Remot
F2 F3
key until Confg
C-3