Home Screen Display - Paradyne COMSPHERE
3610 User Manual

COMSPHERE 3600 Series Data Service Units

Home Screen Display

Pressing the key (double-up arrow) on the front
panel changes the display on the Home screen. The
following is an example of the Home screen display:
Port1 DSU
Local Remot
F1 F2
Port 1 = DTE port or aggregate data stream
currently monitored and reflected by
DTE status indicators
DSU = Operating mode
Auto = Default setting displays until actual data
rate is detected
= Network position of DSU (tributary in
T
this example)
In the following LCD examples, the shaded area below
the front panel shows the additional options that appear
when the or key is pressed. Hardware selections
are filtered when not installed.
To save and change options:
Procedure
1. From the Home screen, as shown above, select
Local (F1). The following screen appears on the
LCD.
Local Mode:
Stat
F1
Confg Ctrl
2. To access the Configuration (Confg) branch, press
the key until Confg appears. Press the
function key below Confg. The following screen
appears.
2-6
Auto T
F3
Bckup Test
F3
F2
December 1996
Configure:
Opts PList
F1
Phone Addr ChgMd Term
Menu
3. Select Opts (for Configuration Options). The
following screen appears.
Load from:
Activ Remt
F1
Usr2 Usr3 FacC
MPTC MPTT
4. The selections on the screen are configuration
option sets stored in the DSU's memory. Table 2-1
lists the Load from menu selections and their
source.
NOTE
You are advised to first save the
factory default settings to store a
set of working configuration
options before changing any
configuration options.
From the Load from menu, any selection except
Remote loads a complete set of configuration
option values into a working buffer.
Dir
F2 F3
SPID
Usr1
F2 F3
FacT FacB
3610-A2-GB46-60