Display Screens - Paradyne COMSPHERE
3610 User Manual

COMSPHERE 3600 Series Data Service Units
Digital Test
Access Digital Test from the second-level menu of the
Test branch. Diagnostics (Diag) must be set to None
from the Confg branch first. To set the amount of time
for the Digital Test (DT):
Procedure
1. Select DSU from the DSU or DBM selection
screen; the DSU Tests selection screen appears.
PRESS: 4 – DT
2. The DSU Digital Test selection screen appears.
PRESS: 1 – Start
3. The Port Number selection screen appears.
PRESS: 2 – Prt1
4. The DSU Digital Test Run Time input screen
appears. The hhh:mm:ss must be fully populated
as shown below.
Customer ID: ORLANDO2
Run Tim: 0:00:00
ENTER Input Form of (hhh:mm:ss):000:08:00
5. Enter the run time for the Digital Test and press
the carriage return <CR>. The following
message appears on the screen: Please wait.
6. The Digital Test completion screen appears.
For further information on Digital Test, refer to
the Digital Test section of Chapter 3.
C-8
Model: COMSPHERE 3610
C t r l – T = Top Menu
C t r l – U = Up Menu
C t r l – V=View H/S
C t r l – x = Disconnect
December 1996

Display Screens

Display screens provide configuration information
and results of performance and device-specific tests. All
information is presented on one async terminal screen.
The Health and Status display shown below can be
accessed by:
Using selection screens and the menu tree path
Ctrl-V from input screens
V from all other screens
Customer ID: ORLANDO2
H/S: 25:12:45 > 9.6 DDS
H/S: 21:10:50 > 9.6 NetI
H/S:
Model: COMSPHERE 3610
T/ C t r l – T = Top Menu
U/ C t r l – U = Up Menu
> DBM:Disable
V/C t r l – V = View H/S
C t r l – x = Disconnect
3610-A2-GB46-60