Paradyne COMSPHERE
3610 User Manual page 34

COMSPHERE 3600 Series Data Service Units
Field Name
Model: 3610 or 3611.
S#: Unit serial number.
DSU SW ver: Software/firmware version residing on DSU or changed using the SW Vers configuration option in
Table 4-4. Refer to Appendix G, Firmware Version Control Information .
Netwrk Addr: Using ADp protocol, the ADp network address appears.
Using DPII protocol, the DATAPHONE II address appears.
DSU Rate: Aggregate DDS data rate set for DSU Rate(Kbps) configuration option. Displays Auto while unit is
locating the data rate. This does not appear for a DBM- X .
DBM SW ver: The software/firmware version residing on the DBM. Not valid with V.32 DBM.
DBM Rate: Aggregate data rate set for DBM Rate(Kbps) configuration option.
DBMtyp: xxx yy.y z Type of DBM installed. xxx can be:
I
V
2wS
4wS
yy.y indicates the DBM's maximum data rate.
z displays P when the Primary Core is set to Yes.
MUX Card: TDM/MCMP. Appears when the MUX circuit card is installed.
MUX App: Currently configured application of TDM/MCMP. Possible values are:
TDM,
MCMP,
CBrdg (central-site bridge),
EBrdg (extended bridge), and
None (TDM/MCMP circuit card disabled)
MUX SW ver: Software version residing on the TDM/MCMP circuit card.
App Modul: ASPEN. Allows Single-Port Async/Sync operation.
CISC or 64CC:
CISC when the Clear Channel with Integrated Secondary Channel chip is present.
64CC when the CISC chip is not present.
LPDA-2. Indicates that the SNA Diagnostic Interface option is installed.
SEQU. Sequoia chip is installed and allows Single-Port Async/Sync operation. Installed in models
3610-A4-xxx or 3611-B4-xxx.
XLOOP. Provides enhanced DDS mode.
3-8
Table 3-2
Identity Descriptions
Information Displayed
ISDN or DBM-I,
V.32 or DBM-V,
2-wire Switched 56 kbps DBM or DBM-D, or
4-wire Switched 56 kbps DBM or DBM-S
December 1996 3610-A2-GB46-60