Configuring For Network Timing; Configuring For External Timing - Paradyne 3172 Operator's Manual

ACCULINK 317x E1 DSU/CSU

Configuring for Network Timing

To configure for network timing,
1. Press F3 to select Cnfig from the top-level menu
screen.
2. Select the configuration option set to be copied
into the Edit area by using the appropriate
Function key. Use the scroll keys, if necessary.
3. Press F1 to select Edit.
4. Press the key from the Edit screen to display
the Gen selection.
5. Select Gen for the general configuration options.
Edit:
NET
F1
6. Select the primary clock source. For network,
press F2 (note that network is also the default).
Pri Clk Src:NET
Next
F1
NOTE
The procedure for configuring the
secondary clock source is similar
to the example shown above. For
more information on configuration
options, refer to Appendix C.
3-34
Chan Gen
F3
F2
NET DTE
F2 F3
March 1996

Configuring for External Timing

To configure the E1 DSU/CSU for external timing,
1. Press F3 to select Cnfig from the top-level menu
screen.
2. Select the configuration option set to be copied
into the Edit area by using the appropriate
Function key. Use the scroll keys, if necessary.
3. Press F1 to select Edit.
4. Press the key from the Edit screen to display
the Gen selection.
5. Select Gen for the general configuration options.
Edit:
NET
F1
6. Select the primary clock source. For external,
press the key until the Ext selection scrolls
onto the screen.
Pri Clk Src:NET
Next
F1
7. Press the appropriate Function key to select
external timing.
Pri Clk Src:NET
Prt n
F1
8. Select the appropriate external clock rate by
pressing the corresponding Function key. This step
is mandatory if you have chosen external clocking.
Chan Gen
F3
F2
NET DTE
F2 F3
Int Ext
F2 F3
3170-A2-GB20-10