Traps: Enterprise-Specific - Paradyne 7123 User Manual

Traps: enterprise-Specific

These traps indicate that an enterprise-specific event has occurred. Supported
enterprise-specific traps are listed below.
Table B-6.
7123-A2-GB20-00
enterprise-Specific Traps and Variable-Bindings
Trap Variable-Bindings
T
enterpriseConfig-
Change(6)
T
enterprisePrimary-
ClockFail(1)
enterprisePrimary-
ClockFailClear(101)
T
enterpriseSelfTest-
Fail(2)
enterpriseTest- For physical interfaces:
Start(5)
T
T
T
September 2001
Possible Cause
devLastTrapString Configuration has been changed
(devHealthAndStatus.- via the menu-driven user
mib) interface, an SNMP Manager, or
auto-configuration after
60 seconds has elapsed without
another change.
String:
'Device configuration change.'
devLastTrapString Operating software has detected
(devHealthAndStatus.- that the primary clock source has
mib) failed.
String:
'Primary clock failed.'
Operating software has detected
that the primary clock source is
operational again.
String:
'Primary clock restored.'
devLastTrapString Unit has completed
(devHealthAndStatus.- (re)initialization and a hardware
mib) failure was detected.
String:
'Self test failed: $ s .' ($ s is the
contents of devSelfTestResult.)
At least one test has been started
on an interface.
ifIndex (RFC 1573)
String:
.0.0 (placeholder)
'$testString test started on
$ifString.' (e.g., 'DTE Loopback
devLastTrapString
test started on Sync Data Port
(devHealthAndStatus.-
S01P1.')
mib
B. SNMP MIBs and Traps
B-9