Paradyne 7123 User Manual page 78

5. Operation and Maintenance
Table 5-4.
5-8
Device Messages (3 of 4)
Message What It Indicates
Permission Denied A file transfer was
attempted, but the:
(Seen at an FTP
T
terminal.)
T
T
Please Wait Command takes longer
than 5 seconds.
Port Inactive The port is disabled, or it
supports synchronous data
and is configured for leased
line mode when a DTE
Loopback was started.
Resetting Device, Yes (or y) was entered in
Please Wait ... the Reset COM Port
usage field of the System
Paused menu.
Save Cancelled Configuration options were
changed, but the Esc key
was pressed or No was
entered in response to the
Save Changes? prompt.
Test Active No higher priority health
and status messages exist,
and a test is running.
September 2001
What To Do
T
User did not have
Level 1 security.
T
Wrong file was specified
when the put command
was entered.
T
User attempted to
upload a program file
from the unit.
Wait until message clears.
No action is needed.
No action is needed.
No action is needed.
T
T
T
T
See your system administrator
to get your security level
changed.
Try again, entering the correct
file with the put command.
Enter the put command
instead of a get command; you
can only transfer files to the
unit, not from it.
See Upgrading System
Software on page 5-25.
Contact service provider if test
initiated by the network.
Wait until the test ends and
message clears.
Cancel all tests from the Test
screen (Path: main/test).
Stop the test from the same
screen the test was started
from.
7123-A2-GB20-00