Paradyne 7123 User Manual page 83

Table 5-6.
Test Status Messages
These test messages appear in the right column of the System and Test Status
screen. You have the option of allowing the test to continue or aborting the test.
See
start and stop them.
Table 5-7.
7123-A2-GB20-00
Health and Status Messages (2 of 2)
Message
Primary Clock Failed
Two Level-1 Users Accessing
Device
Yellow at Network 1
Chapter 6, Troubleshooting
Test Status Messages
Message
DCLB Active, Port-1
DTE External LB Active, Port-1
DTE Init. Ext LB Active, Port-1
DTPLB Active, Port-1
Lamp Test Active
LLB Active, Network 1
Monitor Pttn Active, [Interface]
No Test Active
PLB Active, Network 1
Send Pttn Active, [Interface]
September 2001
5. Operation and Maintenance
What It Indicates
A failure of the primary clock source configured for
the unit is detected and the unit's internal clock is
providing the timing.
This condition clears when the configured primary
clock is restored.
Two Level 1 users are already using the menu-
driven user interface; only two sessions can be
active at one time.
A yellow alarm signal is received on the network
interface. Possible reasons include:
T
Network cable problem.
T
T1 facility problem.
, for more information on tests, including how to
What It Indicates
A Data Channel V.54 Loopback (DCLB) is active on
the data for the user data port.
An external DTE Loopback is running on the user
data port.
The DTE has initiated an external DTE Loopback
on the user data port.
A Data Terminal Payload Loopback (DTPLB) is
active for the specified slot and port.
The Lamp Test is active, causing the LEDs on the
faceplate to flash on and off.
A network Line Loopback (LLB) is active on the
specified interface.
A Monitor Pattern test is active on the specified
interface.
No tests are currently running.
A Payload Loopback (PLB) is active on the
specified interface.
A Send Pattern test is active on the specified
interface.
5-13