Paradyne 7123 User Manual page 86

5. Operation and Maintenance
Table 5-8.
5-16
IP Routing Table Values (2 of 2)
Column What It Indicates
Type The method used to add the route to the table.
T
RIP: The route was discovered through Routing Information Protocol.
The route remains until its TTL (Time to Live) expires, a better route is
provided via RIP, or there is a power reset.
T
Loc: The route was added due to the DSU/CSU's local configuration; a
Default IP Address or an SNMP Manager Initial Route Destination have
been configured.
The route remains until the unit's configuration changes.
T
NMS: The route was added by a Network Management System using
SNMP (Simple Network Management Protocol).
The route remains until there is a power reset of the unit.
T
ICMP: The route was added because an ICMP (Internet Control
Management Protocol) redirect message was received from a router
indicating a better route to the destination. That is, a datagram was
sent to a router and the router is informing the datagram source
through an ICMP redirect message of a better route.
T
Tmp: The route was added as a temporary route in order to respond to
an IP packet that was received.
The route remains until its TTL expires or there is a power reset.
Interface Specifies the interface to be used to reach the destination.
T
COM: Communications port
T
Ethernet: Ethernet port
T
Internal: The interface to be used for software loopbacks or internal
device functions in order to reach the destination.
TTL The Time to Live that was set for the route, in seconds: 1–999
September 2001 7123-A2-GB20-00