3. Configuration
Table 3-4.
3-20
Node IP Options (2 of 2)
Default IP Destination
Possible Settings: None, COM, Ethernet
Default Setting: None
Specifies an IP destination to route data that does not have a specifically defined route.
None – No default network destination is specified. Unrouteable data will be discarded.
This is the recommended setting.
COM – Specifies that the default destination is connected to the COM port. Only appears
when Port Use is set to Net Link (see
Ethernet – Specifies that the default destination is connected to the Ethernet port. Only
appears when the Ethernet port's Interface Status option is enabled. When selected, the
Default Gateway Address must also be configured (see
Options).
September 2001
Table 3-10, Communication Port
Table 3-9, Ethernet Management
Options).
7123-A2-GB20-00