Paradyne 7123 User Manual page 44

3. Configuration
Table 3-5.
Configuring Telnet and/or FTP Session Support
Telnet and FTP options control whether a Telnet or FTP (File Transport Protocol)
session is allowed through an interconnected IP network and the access security
applicable to the session. Two Telnet sessions can be active at a time (see
Table 3-6, Telnet and FTP Session
Table 3-6.
3-22
General SNMP Management Options (2 of 2)
Name 2 Access
Possible Settings: Read, Read/Write
Default Setting: Read
Specifies the type of access allowed to the objects in the MIB. This is the type of access
allowed for external SNMP managers accessing MIB objects using Community Name 2.
Read – Allows read-only access (SNMP Get command). This includes all objects
specified as either read-only or read/write in the MIB RFCs.
Read/Write – Allows read and write access (SNMP get and set commands).
Main Menu Configuration
Telnet and FTP Session
Telnet and FTP Session Options (1 of 3)
Telnet Session
Possible Settings: Enable, Disable
Default Setting: Enable
Specifies whether the DSU/CSU will respond to a session request from a Telnet client on
an interconnected IP network.
Enable – Allows Telnet sessions between the DSU/CSU and Telnet client.
Disable – Does not allow Telnet sessions.
Telnet Login Required
Possible Settings: Enable, Disable
Default Setting: Disable
Specifies whether a user ID and password (referred to as the login) are required to access
the menu-driven user interface via a Telnet session. If required, the login used is the same
login used for an menu-driven user interface session.
Enable – Requires a login to access a Telnet session.
Disable – Does not require a login.
September 2001
Options).
Management and Communication
7123-A2-GB20-00