Halcro SSP100 Owner's Manual page 87

86
Symptom
Hum in tape
playback
Sluggish response
to commands
No picture
Remedy
The tape deck is too close to the power amplifier.
Plugs are making poor contact with sockets.
Video source has a bad video signal.
Power cord is disconnected or power is OFF.
Check if the Standby/On LED (3) is illuminated.
Faulty connections. Try connecting the source to other input connectors.
The internal fuse has blown. Contact your dealer or Halcro at
service@halcro.com
Check "Source Setup" for correct video source selection.
Check "Scaler Setup" if you are using component video outputs, and
confirm that your display device can show the selected formats.
Free Datasheet http://www.datasheet4u.net/